3.3-5V 3-Wire Vibration Sensor Module
R28.90 Inc VAT
This module has a component that is able to detect the vibrations. Depending on the strength of the vibrations, using the built-in comparator on its outputs gives either digital (HIGH / LOW) or analog (0V-5V) signal.
Features
When the VCC and GND are connected, the power indicator will light up.
Put the module on the desktop, adjust the blue potentiometer on the board until the on-board switch indicator lights up, and then slightly turn back the potentiometer untill the indicator light turns off. Hit the desktop with your hand so the vibration shocks the sensor, the indicator light will go on. Vibration stops, indicator light will turn off.
Features
- Comparative output, clean signal, good waveform, strong driving ability, more than 15mA.
- Working voltage: 3.3V to 5V
- Output form: digital switch output (0 and 1)
- Equipped with fixed screw hole, easy to install
- PCB board size: 32mm x 14mm
- Uses the LM393 wide voltage comparator
When the VCC and GND are connected, the power indicator will light up.
Put the module on the desktop, adjust the blue potentiometer on the board until the on-board switch indicator lights up, and then slightly turn back the potentiometer untill the indicator light turns off. Hit the desktop with your hand so the vibration shocks the sensor, the indicator light will go on. Vibration stops, indicator light will turn off.
Module connection details
1. VCC: connect power positive
2. GND: connect power negative
3. DO: digital signal output
Application
It is used for all kinds of vibration triggering, theft alarm, intelligent car, electronic building block.....
Please note that the trigger time is short when small vibration is induced, not enough to drive the relay.
Raspberry Pi Python example
Raspberry Pi Python example
What's in the box?
1 x Vibration sensor module
- Availability: 24 In Stock
- Model: 3 wire vibration sensor
-
Brand:
